Weems-and-plath Endurance 125 Clock Manuel d'utilisateur télécharger pdf (Page 5)

12. When resistance is felt press firmly downwards to cause the Slide 'n

Lock dimples to clip into place. (This is the reverse of step 1 above.)

This will hold the instrument firmly in place to prevent it from moving or

dislodging.

13. To remove the instrument for safe storage, calibration, adjustment or

battery change, reverse steps 8 & 9 of the installation procedure.

Additional tips if mounting more than one instrument.

1. The rear diameter of each instrument is 6" (150mm). If mounting 2 or

more instruments side by side ensure the center points are; A) at least

6-1/2" (165mm) apart; B) at least 4" (100mm) below any ceiling, shelf

or other overhead obstructing coving; and C) 3-1/4" (82mm) above

any lower shelf, floor or table fixture, otherwise Slide 'n Lock dovetail

engagement cannot be made.

2. Also ensure center points are at least 3-1/4" (82mm) away from any

side obstruction or corner.

3. If mounting 2 or more units vertically above one another review items 1

& 2 (this section) regarding clearances to top, side and bottom. Multiple

center points must be at least 6-1/4" (170mm) apart vertically.

4. When mounting instruments to vertically oriented mounting plates,

install lower ones first and progress vertically.

1 2 3 4 5 6 7 8 9 10 ... 20 21

Pas de commentaire

Weems-and-plath Endurance 125 Clock Manuel d'utilisateur Page 5