Weems-and-plath Endurance 125 Clock Manuel d'utilisateur

InstructionsCongratulations! You have purchased arevolutionary new instrument that will provide manyyears of enjoyment. Please read these instructions

7) The initial synchronization of your radio controlled clock movement iscomplete. The second hand will continue to double step until themovement rece

signal. Weather conditions, electrical interference, solar conditions and theposition of the movement’s internal antenna can influence reception.Altho

Why does the A. Under certain weather conditions or insecond hand locations/areas with poor signal reception,keep double it may take several days to r

Barometer/Thermometer/HygrometerOperating InstructionsRefer to the following sections titled Barometer and Comfortmeter.

Barometer Operating InstructionsA barometer is an instrument used to predict a change in weather bymeasuring variations in atmospheric pressure, or th

The moveable pointer at the center of the glass crystal should be set tothe present atmospheric pressure. This will allow you to return to thebaromete

Comfortmeter Operating InstructionsThis Comfortmeter is a combination of both temperature and humidityindicators. Calibration and positioning of hands

Time & Tide Operating InstructionsTime1) Insert AA alkaline battery. Follow diagram on battery housing to makecertain battery is not put in backwa

4) It should be noted that other variables such as wind, atmosphericpressure, the relative position of the moon, and the elliptical pattern ofthe sun

Time & Tide Trouble ShootingClock will not A. Install fresh alkaline battery.run B. Inspect battery contact points, removecorrosion if present.C.

ADDENDUM TO MOUNTING INSTRUCTIONS1. Note the rear diameter of your instrument. If mounting 2 or moreinstruments side by side ensure the center points

Returning your instrument for repairWhen returning for service, be sure to package very carefullyas Weems & Plath® can not be responsible for dam

214 EASTERN AVE. • ANNAPOLIS, MD 21403 • USA410-263-6700 • fax 410-268-8713www.weems-plath.comE-mail: [email protected]

Installation Instructions1. With the instrument face downward on a clean soft surface or lap,and with the 12 o'clock position of the instrument t

6. Remove the mounting plate and drill the wall marks with a 3/32" or2.00mm drill bit.7. The mounting plate is designed with stepped mounting hol

12. When resistance is felt press firmly downwards to cause the Slide 'nLock dimples to clip into place. (This is the reverse of step 1 above.)Th

5. When removing instruments on vertically oriented mounting plates,demount top one first and progress downwards.Quartz Clock Operating Instructions1)

Quartz Clock Trouble ShootingClock will not A. Install fresh alkaline battery.run properly B. Inspect battery contact points, removecorrosion if prese

6) If clock stops, it is most likely due to a dead battery. Remove thebattery immediately as it might leak acid causing damage to themovement.*7) If c

3) Insert a “AA” alkaline battery in back of movement. Follow diagram onbattery housing to make certain battery is not put in backwards. Useonly alkal